Dirko HT red (acetoxy curing) is a high-quality, high-temperature-resistant, single-component silicone-based sealing compound with permanently elastic properties. It offers excellent adhesion to all common metals, cast iron, plastics (except PE, PP and PTFE) and glass. Through reaction with air humidity, Dirko HT red cures to silicone. The product is characterized by a very wide range of applications.
Resistance to
- Mineral oils including additives
- Synthetic oils
- Lubricating greases
- Coolants
- UV radiation
- Cold and hot water
- Salt water
- Cleaning agents
- Weak acids and alkalis
Typical applications
- Valve covers
- Oil pans
- Water pumps and oil pumps
- Differential housings
- Gear housings
- Transmission oil pans
- Thermostat housings
- Timing housings
- Axle covers
- Flange connections
- Headlights
- Tail lights
- Battery boxes
- Color Red
- Oil resistant Yes
- Maximum temperature +315 C short-term
- Maximum continuous temperature -60 C to +300 C
- Chemical base Acetoxy silicone
- Components Single component
- Maximum sealing gap 2.0 mm
- Hardness 30 5
- Density 1.1 0.2 g/ml
- Curing Room temperature vulcanizing RTV
- Consistency Paste-like, non-sag, permanently elastic after curing
- pH value Neutral
- Electrical conductivity Insulating
- Elastic modulus at 100 percent 0.6 0.2 N/mm2
- Tensile strength 2.9 0.2 N/mm2
- Elongation at break 600 100 percent
This Product was added to our catalogue on 23/04/2024.
Instagram
Youtube
Facebook